N-Clear V2 Controller User Guide
Special Instructions for V2 Controllers
How to Tell if Your Controller is V2 or V1
Press the MODE button to switch among different modes.
| Controller Version | MODE Button Behavior | Available Modes | Description |
|---|---|---|---|
| V1 |
Press the MODE button to switch between two modes: • MODE light off → Normal Mode • MODE light blinking → High Efficiency Mode |
2 Modes | Original version with standard sensor-based control. |
| V2 |
Press the MODE button to switch between three modes: • MODE light off → Default Mode • MODE light blinking → Long Delay Mode • MODE light on (solid) → Timer Mode |
3 Modes | Current controller version that adds Long Delay and Timer Modes for additional control options. |
Tip: If your controller’s MODE light can stay solid on, your controller is a V2.
MODE (V2)
| Mode | MODE Light | Description | Recommended For |
|---|---|---|---|
| Default Mode | Off | Motor turns when the sensor remains submerged for more than 30 seconds. | Normal daily use. |
| Long Delay Mode | Blinking |
Motor turns only after the sensor remains continuously submerged for more than 10 minutes. You can leave the roller powered on during feeding. If the feeding pause and the time needed for the water level to settle keep the sensor continuously submerged for less than 10 minutes in total, the fleece will not advance. This lets you use your usual feeding routine without switching the roller off and back on. |
Tanks where the return pump is often turned off. |
| Timer Mode | On (solid) | Motor runs for 7.5 seconds every 12 hours, not affected by the sensor. One roll lasts about 30 days. When the roll is small (new), each turn moves less fleece; as it grows, each turn moves more. This is normal and does not affect performance. | Tanks with raised water levels or users who prefer fully automatic operation. |
ALARMS
| ALARM Light | Meaning | How It’s Triggered | What Happens / How to Fix |
|---|---|---|---|
| Off | Normal operation. | Default state when the controller is functioning properly. | No action needed. |
| Blinking | Feeding pause. | Triggered by pressing the PAUSE button once. | Automatically resumes after 30 minutes, or press the PAUSE button twice to return to normal immediately. |
| On (solid) | Manually stopped. | Triggered by pressing the PAUSE button twice. | Automatically resumes after 12 hours, or press the PAUSE button once to return to normal immediately. |
| On + Beeping | Alarm — motor has been running too long, often caused by incorrect water level or sensor height. | Triggered automatically when the motor runs continuously beyond its safe limit. | Check water level and sensor position. Auto-resets after 12 hours but may trigger again if the issue is not fixed. Press the PAUSE button once to force reset. |